How to Save $100 to $200 in Gas Just by Checking Your Tires.

You can save 4% on your annual gas costs if you keep your tires at the recommended Pounds per Square Inch (PSI). That could save your family from $100 to $200 dollars annually. To determine and maintain the proper tire pressure requires very little effort. The steps are listed below.

The manufacturer recommended air pressure for the tires on your car can vary greatly from model to model. It can range anywhere from 20 pounds to 50 pounds per square inch. So how do you find the correct pressure for your tires?

The correct tire pressure for your vehicle is listed on the information placard. This placard is normally located on the edge of one of the doors, the inside post of one of vehicle's doors or inside the glove compartment, trunk, or fuel door. Your owner's manual should include the correct tire pressure or direct you to the placard's location on your vehicle.

Many drivers have the mistaken idea that the numbers on the tire sidewall indicate the correct pressure. This couldn't be farther from the truth. The information on air pressure listed on the tire is the maximum tire pressure that can safely be used in that grade tire. It also indicates the highest pressure that should be used in order to load the maximum weight in the vehicle.

When you find the information listing the correct tire pressure, you need to physically measure air pressure in all four tires to guarantee they are inflated properly. There are a few steps involved in doing this correctly.

To correctly measure and guarantee the proper tire pressure:

Step 1:

Make sure you have a tire pressure gauge. There are many kinds. You do not need an expensive one. A gauge with a dial is easier to read than the pop up kind.

Step 2:

Find the recommended inflation pressure for your tires on the vehicle information placard. Check the owner's manual for its exact location. A sight inspection is not an appropriate way to measure the air pressure in your tires.

Step 3:

A tire that is hot, or has just been driven on will have a higher air pressure than that same tire when it is cold. A cold tire is one that has not been driven for at least 3 hours or has been driven 1 mile or less. Air pressure should only be measured when tires are cold. If you measure warm tires your results will be faulty.

Step 4:

Complete tire inflation pressure check: Remove the cap from the valve on one tire, press the pressure gauge onto the valve and take a pressure reading. Make sure you press the pressure gauge completely onto the valve. You should not hear any air escaping from the tire as you are taking the reading. If air is escaping, remove the gauge from the valve and try reseating it again.

Step 5:

If you find the pressure is low, add air to the tire until you get to the correct air pressure. If you find the tire is over inflated or you put too much air in the tire, you can lower the pressure by pushing on the metal stem at the center of the valve which will allow air to escape from the tire. Measure the air pressure again to make sure you have the correct level and adjust the air in or out again if needed. Repeat measuring and adding or purging air until the desired pressure is reached.

Step 6:

Follow this same procedure for the other three tires.

It is recommended that you check your tire pressure at least once per month. Air can and will leach from a tire over time. Heat and use will affect the rate at which a tire loses air. Checking once a month will assure that you are maintaining the correct pressure all year round.

This is one of the easiest ways to save $100 to $200 dollars of gas costs. Just follow this advice and you will have more money in your pocket.

Article Source: http://www.christiannotepad.com

Scott Siegel is the author of a 143 page book of industry insider information on saving gas and money at the pump. Visit us to learn how you can get better gas mileage. Find out how to increase gas mileage.
Don't reprint the same version as everyone else. Get your own unique content lower gas costs article here.