High Speed and Ultra High Speed Burnishing (1000-2500 RPM)

Recommended Supplies and Janitorial Equipment:

EPA Registered Cleaner/Disinfectant
All Purpose Detergent Cleaner
High/Ultra High Speed Burnisher
High/Ultra High Speed Pad(s)
Dust Mop, Handle, Frame
Treated Dust Mop
Dust Pan and Counter Brush
Scraper/Putty Knife
Wet Floor Signs
Wet Mop(s)
Rubber Gloves
Mat(s)

Recommended Method:

As in all cleaning procedures, the first step is to gather the recommended janitorial equipment together and bring them to the area to be cleaned.

Battery Operated:
Remove all debris and dust from the floor to be burnished using a clean, treated dust mop.

Place wet floor signs designating area to be damp mopped.

Damp mop the floor area. Use the scraper/putty knife to remove gum and other debris from floor while mopping. Allow the area to dry.

Install burnishing pad on the machine.

Dry burnish the floor in an in-line direction up the floor and back down the floor (do not swing back and forth).

Repeat the process until the entire area has been burnished.

Dust mop the floor area using a treated dust mop.

Be sure to inspect your work and correct any steps you might have missed.

Finally, as in all cleaning procedures, allow time to clean up and return the janitorial equipment to the storage area.

When you are finished, wash hands and dry thoroughly.

Article Source: http://www.christiannotepad.com

Great janitorial tips and janitorial information by Lee Harris can be found at www.monsterjanitorial.com. Lee Harris is an expert in the janitorial industry and can answer all your questions about janitorial equipment and how to save money on these types of products.